How to Replace Patches Of Carpet

As our carpets age they can start to show signs of wear and tear. Sometimes those indicators of a worn down or slightly stained carpet can become more than a bit too much to bear, leaving you wondering if it’s time to get something brand new installed. 

But who has the money to get the old one torn up and a new one laid down? If the answer is not you, then you might want to try a much cheaper alternative, one you can do all by yourself for next to no cost. All it takes is a little ingenuity and patience, or better yet, just follow our simple set of steps below. 

Patching Carpet

Not all damage can be fixed with a patch. In fact you’re going to want to choose carpet repairs carefully if you expect the work to look good after it’s finished. That means using a patch to remove small stains or worn down areas that are roughly two inches or smaller. Anything larger and you may have a tough time hiding the evidence there was any work done at all. 

This is because the seams can be obscured but they won’t be totally invisible upon closer inspection, so if you remove less carpet, it will be harder to see the patch. 

Easy Steps

So the next time you’re carpet cleaning torrance ca and you notice a spot that just won’t come out, you can simply patch up the area instead of laying down a whole new carpet. Here is how you do it: 

Find Some Remnants

In order for the patch to be truly effective you first need to find a remnant of the carpet you are attempting to fix. It’s possible you have some left over carpet remnants lying around from when you had it installed. 

Go track those down, you’ll need them. If you can’t find any of the remnants, then you might want to contact the store where you bought the carpet and see if they have some spare samples or small square footage portions. 

Outline your Patch

Depending on the size of the damage (remember, it needs to be small), you need to get a small round or square receptacle of some kind and place it over the area for repair. Trace an outline around the edge of the receptacle you’ve chosen. 

Do this around the area you wish to have removed from the carpet. Once you’re done, grab one of those remnants. 

Now do the same thing on the remnant swatch you’ve secured for the job. Measure the same outline with the same receptacle so that it matches the hole you’re about to make in your carpet. 

Once you’re done, take a sharp utility blade and cut the patch from your remnant. Then, turn to the outline on the carpet and cut that out as well. 

Remove the Damage

Now that you’ve made an incision in the carpet, pull that severed portion of carpet out. Just tear it right up off of the floor. You should see the pad or whatever else has been laid beneath your carpet when it was installed by the contractor. 

When you’re done you should have two identical portions of carpet in the exact same size and shape – one stained or worn, the other looking good as new. 

Attach the Carpet Tape

In order for the patch to stay in place, it needs to be held there with carpet tape. So grab two or three pieces and lay them down inside of the hole so that they are layered completely within the divot you’ve just created. Be careful not to have any of the tape sticking out from the hole in order to maintain an even, smooth appearance. 

Press the Patch into the Hole

Now it’s time to make the repair. Take the patch you cut from the remnant and place it into the hole in your carpet. Push it in firmly and apply enough pressure for the tape to take hold of the patch. Just be sure your carpet texture is in the same direction as the rest of your carpet. 

That might mean you need to rotate the patch to ensure that it matches the carpet perfectly. Just be sure the patch is set in the right direction before you press down onto the carpet tape underneath. 

Blend the Edges

Finally, you want to comb the fibers along the seams so that they are hidden from view. You might need to try it a few times to ensure that your edges are blended completely. To make it even easier to accomplish this, you may also need to trim some longer, errant fibers so that it looks like the surface of your carpet has been untouched by a knife blade.